Go Back   Subaru Impreza Forum - WRX STI Rally Performance Tuning > Subaru Impreza Technical Area > Technical General

Subaru Impreza Forum

Boost problems after rad hose split!???
Reply
 
LinkBack Thread Tools Display Modes
Old 01 May 2009, 08:54 AM   #1 (permalink)
Fresh Scooby
 
Join Date: Sep 2008
Posts: 11
Boost problems after rad hose split!???

Hi

Erm, ok, heres what happened, on way home from london (to cambridgeshire) id pulled into south mimms for some munch. After leaving i got a bit further up and and on slowing to join slip road i noticed steam .

Pulled over asap, yep somethings wrong lol......got a bit further, waited, filled up water, got another 10 mins up the road, stopped, cooled, more water... got about 10 mins from home and water temp then rose to 103 (after sitting between 84 - 91 (normal for me) then 95 for some time. Anyway, i topped it up again and got it home. Ive replaced the top rad hose which was nicely split and after testing all seems great again with regards to running temps etc etc

HOWEVER.... my car will not boost over 1 bar im not sure if its boost cut or fuel cut but its buggin me. My "B" setting on my AVC-R is set to 1.10, my "A" setting is 1.3 with boost duty % upped so actual boost is 1.50 then backs off to 1.3 at higher revs (i had boost creep under load hence the adjusted %)...... this has been running sweet like this since Simon from jollygreenmonster mapped it etc.

I cant work out why now i cant boost over 1 bar ... any ideas!? anything i should check?? anything i can reset (safe / limp mode)??

I CAN rev over 4k (someone mentioned 4k to me regarding limp mode)

My impreza has the full apexi setup inc. fc hand commander + avc-r boost controller.

Thanks in advance

James
Offline   Reply With Quote
Old 05 May 2009, 02:06 PM   #2 (permalink)
Fresh Scooby
 
TUNER's Avatar
 
Join Date: Dec 2008
Location: Blackburn
Posts: 41
Re: Boost problems after rad hose split!???

Hello mate, check your ht leads as when i had the same problem with boosting and number one ht on the ignition coil was corroded and wasnt connecting properly. Also check all the boost pipes. Does it by any chance backfire and run lumpy?
Offline   Reply With Quote
Reply

Bookmarks


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
boost problems gringo8585 Engine Bay 5 27 Feb 2009 06:45 PM
boost gauge problems chriswrximport Subaru Impreza Discussions 5 12 Sep 2008 04:24 PM
boost and idle problems d6nyb Engine Bay 5 17 Nov 2007 11:26 AM
Help 1995 turbo 2000 boost problems projectsubaru Subaru Impreza Discussions 8 03 Mar 2007 12:23 AM
Boost problems at motorway speeds? Mr_Wid Engine Bay 18 07 May 2005 09:34 PM


All times are GMT. The time now is 10:36 PM.



Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2019, vBulletin Solutions, Inc.
LinkBacks Enabled by vBSEO 3.6.0 PL2 © 2011, Crawlability, Inc.