Unable to select gears

[stiimpreza1984]

First post in many years unlike the old days this site was my life well I'm back now . Basically my Version 6 Type RA was off the road for 6 months I can't select gears while the engine is running however I can select them when engine is not running. Before I started it I engaged the clutch as its clutch start but pedal went to the floor however lifted it back up and there was pressure felt again. My Q is -is the clutch disc stuck on the input shaft splines or could it be stuck to flywheel or pressure plate? Could I simply put the car in gear with engine off then turn it on and try to take off? Or would I end up doing more damage? Bearing in mind I replaced both the master and slave over 3 years ago but there's only Max 5k miles on them not even. Your comments will be appreciated thanks good to be back.

[STIDave]

I had this on one of my old cars once. I engaged gear, started and let the clutch up slowly, after that it was fine. I'm guessing the plate was stuck but not entirely sure. If it happen to my Scooby I would still try it tbh.

[stiimpreza1984]

Cheers Dave, it managed to work itself loose after a few pumps of the clutch thanks again.

[The Pilot]

Give it a bleed now and then Darren if the RA is laid up,have to pump mine if i feel the need to get her out for a blast...

[stiimpreza1984]

Cheers Ed will do