clutch help

[jonoelb]

hi all 2 questions
1st is this my clutch or clutch master cylinder my pedel sticks half way but changes gear fine is my cylinder loosing pressure and my release bearing making a noise is this coz it's not fully on the pressure plate


2nd how hard is it to remove the gearbox and change my clutch at home?

[The Pilot]

could well be bud,this can also happen when the fluid is low,so check your levels,as for DIY Clutch replacement,it can be done,BUT you will need plenty of height,as the cat,prop and obviously the drive shafts need to be dropped,definatly not a "flat on your back" in the garage or driveway job

[jonoelb]

Cheers pilot

[jonoelb]

just checked my slave cylinder, should u b able to push the rod back with no force

[The Pilot]

erm,no...

[stiimpreza1984]

Originally Posted by jonoelb

hi all 2 questions
1st is this my clutch or clutch master cylinder my pedel sticks half way but changes gear fine is my cylinder loosing pressure and my release bearing making a noise is this coz it's not fully on the pressure plate


2nd how hard is it to remove the gearbox and change my clutch at home?

As for the 1st problem could be either master cylinder or slave but as you getting problems from release bearing Id change the clutch 2nd I only take the clutch out on a ramp in a garage