Help with fitting my gauges

[steve_koz_MY00]

Hi All,

I am new to the scooby as a car - this is my first and she is wonderful, im loving every minute.

There are a few modification routes i'll be travelling down and as such purchased a number of gauges to keep myself in the know about how the car is running.

The gauges are

Air Fuel Ration
Oil Temperature
Boost

I am not a total mechanical lamen, but i have never gone about wiring in gauges and fititng them.

I ideally need a step by step guide on how to fit them or alternatively a friendly fellow scoob fanatic to lend me a help hand in the midlands area. I've been quoted by some companies in excess of £200 to get them fitted and with a new baby and xmas and bills im dead set against spending that kind of cash on something i cannot see being that hard to someone in the know!!

Any help, links, advice, guidance would be helpful.

Cheers

Steve

[scoobyman]

get the power from the ignition area strip back a small bit of wire and test which one has power only when ignition is on and then the neutral wire all gauges them the same then solder them.go through firewall out into the enginebay should be up underneath at clutch little black rubber through that.hook turbo gauge to dumpvalve pipe,hook the oil temp to the oil filter [might have to buy a sandwhich plate i had to.the air fuel ration i dont have that

[subaru5468]

where in the midlands are u from

[scoobyman]

whats wrong with that thats how i done mine

[steve_koz_MY00]

im in sutton mate, work in solihull.